Order Unstable Blade Set (1 main sleeve & 2 quillon blades)

For Vader's Vault Neopixel Crossguard Lightsabers go here: https://www.etsy.com/sg-en/listing/748888098/vaders-vault-unstable-sleeve-set
For Galaxy's Edge/Savi's Workshop Lightsabers go here: https://www.etsy.com/listing/774810777/galaxys-edge-unstable-sleeve-set

PLEASE NOTE: IF YOU ARE ORDERING FOR AN INSTALLED 2.0 DIRECTLY FROM KORBANTH WITH THE INTENTION OF USING THE LEDS FROM THE EXISTING BLADES PLEASE CHECK BLADE DIAMETER, RECENT PRE-INSTALLED HILTS FROM KORBANTH ARE BORED OUT TO 7/8" AND NOT THE 20MM STOCK SIZE.

These hollow blades (sides are blades, main is a sleeve) are designed for LED/Neopixel fx lightsabers to emulate the appearance of Kylo Ren's unstable blades as seen in The Force Awakens and The Last Jedi. They are empty/hollow and do not come pre-installed with neopixels.

They are printed in a translucent flexible TPU filament to allow for maximum light diffusion and durability and should stand up to duelling. If there are, for example, neopixels installed in the quillons it is possible that these could be damaged with duelling.

The main blade sleeve is about 9 inches long and will fit a 1 inch OD blade. I also have 7/8ths available but haven't created a drop down option for it. If you want 7/8ths please add this note to your order and message me :)

The quillon blades are hollow, empty and around 6.5 inches long total. This length includes a 1 inch long section that fits into the bladeholder. There are several options in the "Saber Model" drop down that should cover most people's needs but if you have a weird bladeholder (15/16ths inch for example) please contact me with accurate measurements before you place your order and I should be able to accomodate :)

I have done my best to tune the tolerance so that these will stay on the blades with friction and they should fit any 1" (or 7/8ths if you chose that option) blades. Unfortunately some manufacturers have quite a wide margin for acceptable tolerance and may produce over or under sized blades and still call them 1" (or 7/8ths). If the blade is too loose to stay on with friction a small dab of E6000 or hot glue will hold it in place whilst still being removable when desired.